projects:3dprinting:anycubic_i3_mega
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:3dprinting:anycubic_i3_mega [2019/03/09 03:07] – [Software modification] admin | projects:3dprinting:anycubic_i3_mega [2019/11/16 22:27] – [Distribution circuit board] admin | ||
---|---|---|---|
Line 24: | Line 24: | ||
^ Bracket for BLTouch | ^ Bracket for BLTouch | ||
| {{: | | {{: | ||
- | Please note that the shim which can be seen on the picture was required in order to get a total height | + | Please note that the shim which can be seen on the 2nd and 3rd picture was required in order to get a total distance |
At the print head a tiny strip board was added as carrier for a 3-pin jst connector. This would make it easier to separate the print head if necessary. Kapton tape was used to prevent any contact to adjacent pins. The square opening at the frame of the print head was made larger so the jst connector would also fit. Please note the difference between the last two pictures: | At the print head a tiny strip board was added as carrier for a 3-pin jst connector. This would make it easier to separate the print head if necessary. Kapton tape was used to prevent any contact to adjacent pins. The square opening at the frame of the print head was made larger so the jst connector would also fit. Please note the difference between the last two pictures: | ||
Line 37: | Line 37: | ||
Todo. See: [[http:// | Todo. See: [[http:// | ||
===== Distribution circuit board ===== | ===== Distribution circuit board ===== | ||
- | For easier upgrading mechanical parts of the printer, | + | The external connections |
- | In order to design this board, it is first necessary to reverse engineer the original circuit board: | + | The original circuit board was analyzed using a flatbed scanner: |
^ Anycubic I3 MEGA distribution circuit board (with and without annotation) | ^ Anycubic I3 MEGA distribution circuit board (with and without annotation) | ||
Line 45: | Line 45: | ||
| {{ : | | {{ : | ||
- | Click on either link above to find both sides of the circuit board | + | Then with KiCad schematics were drawn and a new circuit board was designed: |
+ | |||
+ | ^ I3 MEGA HUB-II distribution circuit board ^^ | ||
+ | | {{ : | ||
+ | | // | ||
+ |
projects/3dprinting/anycubic_i3_mega.txt · Last modified: 2020/11/09 01:16 by admin