Differences

This shows you the differences between two versions of the page.

--- projects:3dprinting:anycubic_i3_mega [2019/03/09 03:05] – admin
+++ projects:3dprinting:anycubic_i3_mega [2019/03/09 03:16] – [Hardware modification] admin
@@ Line 24: / Line 24: @@
 ^  Bracket for BLTouch  ^^^^^
 |  {{:projects:3dprinting:01.bltouch_mount_e.png?direct&178x200}}  |  {{:projects:3dprinting:01.bltouch_mount.png?direct&88x200}}  |  {{:projects:3dprinting:01.bltouch_mount_b.png?direct&172x200}}  |  {{:projects:3dprinting:01.bltouch_mount_c.png?direct&159x200}}  |  {{:projects:3dprinting:01.bltouch_mount_d.png?direct&163x200}}  |
-Please note that the shim which can be seen on the picture was required in order to  get a total height of 25.0mm. The [[http://www.auditeon.com/xyz/01.BLTouch_mount_e.fcstd|final design]] (FreeCad fcstd) is in a single piece and has this height already corrected.
+Please note that the shim which can be seen on the 2nd and 3rd picture was required in order to get a total distance of 25.0mm. The [[http://www.auditeon.com/xyz/01.BLTouch_mount_e.fcstd|final design]] (FreeCad fcstd) is in a single piece and has this height already corrected.
 At the print head a tiny strip board was added as carrier for a 3-pin jst connector. This would make it easier to separate the print head if necessary. Kapton tape was used to prevent any contact to adjacent pins. The square opening at the frame of the print head was made larger so the jst connector would also fit. Please note the difference between the last two pictures:
@@ Line 35: / Line 35: @@
 ==== Software modification ====
+Todo. See: [[http://marlinfw.org/docs/configuration/configuration.html]]
 ===== Distribution circuit board =====
 For easier upgrading mechanical parts of the printer, it would be beneficial to exchange the external connections to more robust and versatile DSUB type connectors. For this a new circuit board is required to replace the current board.